PLEASE READ THE MAIN INSTRUCTIONS BEFORE COMMENCING, THEN REFER TO THIS SUPPLEMENT.
This mounting has been designed specifically for use with the Valkyrie and must be used in conjunction with the Beam Mounting kit. With the bike in it’s resting position on the side stand take the mounting and position it under the frame rail situated between the swing arm and rear of the gearbox casing. The mounting is sized to fit between the stand bracket casting and the R/H frame rail. With this in position place the “U” bolt over the frame then through the plate, now secure the two M8 wing nuts provided, (this becomes part of the bike for lifting yet can be removed at will). Take the EAZYRIZER lift complete with the two Beam Mountings (slots facing inward) and securely lock them near to the ends or the main lifting arm, now slide the lift under the bike from the R/H side aligning the rear beam under the mounting previously secured to the bike frame. At this stage holding the bike vertical, turn the screw shaft manually in a clockwise direction to raise the lift and support the bike while you secure the two lower M8 bolts (mounting plate to beam assembly).
See diagram below for reference.